Pacer TX-750 (650-850 cP) 20g
TX Temperature Extended: Single component, high temperature cyanoacrylates for use at service temperatures up to 300 degrees F. Best for wire tacking and component bonding to printed circuit boards before and after wave soldering. TX chemistry is specially designed to permit rapid “wire tacking” to plain printed circuit boards; boards covered with solder masks; and provides the best performance for “tacking” when board processing includes water washing operations. These formulations work well on chromate conversion coatings and oily parts.
Excellent impact strengths of 10-15 lbs/in2 can be obtained.
SLOW CURE:
Allows work piece alignment 750cP viscosity allows up to .010″ gap fill capability
Meets MIL-A-46050C Type II Class 3
ZAPTX750
Specific References
16 other products in the same category:
TX Temperature Extended: Single component, high temperature cyanoacrylates for use at service temperatures up to 300 degrees F. Best for wire tacking and component bonding to printed circuit boards before and after wave soldering. TX chemistry is specially designed to permit rapid “wire tacking” to plain printed circuit boards; boards covered with solder masks; and provides the best performance for “tacking” when board processing includes water washing operations. These formulations work well on chromate conversion coatings and oily parts.
Excellent impact strengths of 10-15 lbs/in2 can be obtained.
SLOW CURE:
Allows work piece alignment 750cP viscosity allows up to .010″ gap fill capability
Meets MIL-A-46050C Type II Class 3